Hg Cleaning
Solution-102 (HgCS-102)
(Catalog # RP-103)
General Information - Application Information - MSDS
(Catalog # RP-103)
General Information - Application Information - MSDS
|
Hg Cleaning
Solution-102 (HgCS-102)
(Catalog # RP-103) General Information - Application Information - MSDS |
- HgCS-102 is specifically formulated to clean mercury from concrete, metal and plastic surfaces. Before using the product, all debris should be removed from the surface to be cleaned. Once this is accomplished, the following steps should be taken.
- Application instructions are as follows:
- Apply HgCS-102 by spraying, painting, etc., so that the chemical comes in contact with all surfaces to be cleaned. To clean pipe and tubing, spray product on all surfaces to be cleaned.
- If possible, the surface should then be brushed to agitate the product to enhance cleaning. This may not be possible with pipe and tubing. Using high pressure when applying product will be helpful.
- Allow the material to be in contact with the surface to be cleaned for approximately 15 (fifteen) minutes. For highly contaminated surfaces or where there is heavy sludge in pipe or tubing, allow a set time of 20 to 25 minutes. For subsurface cleaning allow 1(one) our set time.
- HgCS-102 can be removed with high pressure water or steam. If in an area where this is not possible, simply clean by applying water and wiping with absorbent cloths.
- Effluent should be collected and disposed of in accordance with applicable State or Federal Regulations.
- If more than one application is needed, repeat steps A through E.
Note: When cleaning pipe or tubing, the solution may be used more than once if contamination level of the solution is low.