|
- Pipe X- Metal X is specifically formulated to clean metal, plastic and other surfaces except concrete. All sludge must be removed from the surface of the metal to be cleaned. Once this is accomplished, the following steps should be taken.
- Application instructions are as follows:
- Apply Pipe X-Metal X by spraying, painting, etc., so that the product comes in contact with all surfaces to be cleaned.
- If possible, the surface should then be brushed to agitate the product to enhance cleaning.
- Allow the material to be in contact with the surface to be cleaned for approximately 15 (fifteen) minutes. For highly contaminated surfaces allow a set time of 20 to 25 minutes.
- Pipe X-Metal X may be removed with high pressure water or steam. If in an area where this is not possible, simply clean by applying water and wiping with absorbent cloths or wipe clean with water and cloths.
- Effluent should be collected and disposed of in accordance with applicable State or Federal Regulations.
- If more than one application is needed, repeat steps A through E.
Note: For surfaces with minimum contamination levels Pipe X-Metal X may be diluted up to 5 to one with water.