Pesticide Cleaning Solutions (PCS-100) (Catalog # RP-107) General Information - Application Information - MSDS

1. PCS-100 is specifically formulated to clean pesticide contamination from metal, plastic and all other surfaces. All sludge's must be removed from the surfaces to be cleaned. Once this is accomplished, the following steps should be taken.
   
   
2. Application instructions are as follows:
   
   
   1. Apply PCS-100 by spraying, painting, etc. so that the product comes in contact with all surfaces to be cleaned.
      
      
   2. If possible, the surface should then be brushed to agitate the product to enhance cleaning.
      
      
   3. Allow the material to be in contact with the surface to be cleaned for approximately 15 minutes. For highly contamination surfaces allow a set time of 20 to 25 minutes.
      
      
   4. PCS-100 may be removed with high pressure water or steam. If in an area where this is not possible, simply clean by applying water and wiping with absorbent cloths or wipe clean with water and cloths.
      
      
   5. Effluent should be collected and disposed of in accordance with applicable State or Federal Regulations.
      
      
   6. If more than one application is needed, repeat steps A through E.
      

Note: For surfaces with minimum contamination levels PCS-100 may be diluted up to 5 to 1 with water.

---

Back to Main Catalog